News

Daily Cleaning: • Rinse with water • Wipe with a soft sponge and neutral detergent • Rinse thoroughly with hot water • Dry with a microfiber cloth Deep Cleaning: • Sprinkle with baking soda • Spray with white vinegar • Let it sit and scrub • Rinse thoroughly • Dry • Lightly wipe the sink surface with a small amount of stainless steel polish

PVD coating (Physical Vapor Depsosition) is a coating technology that deposits metal or ceramic materials onto the surface of a 304 stainless steel sink in a vacuum environment through physical vaporization, evaporation, or sputtering. This process does not involve chemical reactions, resulting in a high-purity, dense, and strongly adhesive coating.

It evaporates a metal target into ions, which are then deposited onto the surface of a 304 stainless steel sink, forming a dense, strong, and corrosion-resistant metal film. This film is very thin, yet possesses extremely high strength and adhesion, significantly enhancing the appearance and performance of the 304 stainless steel sink.

To prevent water stains from accumulating on the surface of stainless steel kitchen faucets, wipe the faucet surface dry immediately with a clean, soft cloth after each use, especially areas prone to water residue such as the faucet bends, base, and spout.

Undermount sinks are primarily fixed in the following ways: 1. Wrap-around metal brackets (common on stone countertops) 2. Structural adhesive bonding under the countertop (glass glue/marble glue/epoxy resin) 3. Countertop weight pressing structure (some sinks have pre-drilled edges that prevent upward passage) Based on the above reasons: Undermount sinks almost never can be removed upwards; replacement must be done by disassembling from below and removing them downwards.

From the perspective of material and structure, stainless steel undermount sinks inherently have good waterproof performance. As long as the sink material is qualified and the sink body has no cracks, it will not leak due to the sink itself during daily use.

Yes, white quartz sinks do have a certain risk of yellowing over time. However, don't worry too much, as this change mainly stems from resin aging, pigment deposition, water quality issues, and improper cleaning methods, rather than a change in the quartz particles themselves.

If you care about maintaining a perfect surface appearance, composite sinks are more scratch-resistant; If you prioritize impact resistance and long-term stable use, stainless steel sinks are more durable.

Minor Scratches are Not Permanent Most of the fine scratches seen on stainless steel kitchen sinks are actually minor surface wear. These scratches are typically: • Very shallow • Irregularly distributed • More noticeable when the angle of light changes • Can be faded or even disappeared with appropriate methods

In actual design and installation, the standard depth of undermount kitchen sinks is typically between 18 cm and 25 cm (approximately 7 to 10 inches). However, this is only a general reference range. The specific choice should be made in conjunction with the kitchen countertop height and the user's height.