News

Strong Adhesives are a Core Securement Method A key to securing an undermount sink is using professionally applied stone adhesive, structural adhesive, or epoxy adhesive. High-quality structural adhesives can withstand long-term tensile, sagging, and impact forces, ensuring the undermount sink's stability.

High-curve kitchen sink faucets have a higher spout position, typically rising 25-45 cm from the countertop. Low-curve kitchen sink faucets have a lower spout position, typically 15-25 cm high. They have a more compact and simpler appearance and are often used in small kitchens or areas with low wall cabinets.

Countertop sinks, due to their raised edges, easily accumulate limescale, grease, and food residue. Undermount kitchen sinks, with their recessed design, allow dirt from the countertop to be directly swept into the sink with a cloth or scraper.

Daily Cleaning: • Rinse with water • Wipe with a soft sponge and neutral detergent • Rinse thoroughly with hot water • Dry with a microfiber cloth Deep Cleaning: • Sprinkle with baking soda • Spray with white vinegar • Let it sit and scrub • Rinse thoroughly • Dry • Lightly wipe the sink surface with a small amount of stainless steel polish

It evaporates a metal target into ions, which are then deposited onto the surface of a 304 stainless steel sink, forming a dense, strong, and corrosion-resistant metal film. This film is very thin, yet possesses extremely high strength and adhesion, significantly enhancing the appearance and performance of the 304 stainless steel sink.

To prevent water stains from accumulating on the surface of stainless steel kitchen faucets, wipe the faucet surface dry immediately with a clean, soft cloth after each use, especially areas prone to water residue such as the faucet bends, base, and spout.

Undermount sinks are primarily fixed in the following ways: 1. Wrap-around metal brackets (common on stone countertops) 2. Structural adhesive bonding under the countertop (glass glue/marble glue/epoxy resin) 3. Countertop weight pressing structure (some sinks have pre-drilled edges that prevent upward passage) Based on the above reasons: Undermount sinks almost never can be removed upwards; replacement must be done by disassembling from below and removing them downwards.

Minor Scratches are Not Permanent Most of the fine scratches seen on stainless steel kitchen sinks are actually minor surface wear. These scratches are typically: • Very shallow • Irregularly distributed • More noticeable when the angle of light changes • Can be faded or even disappeared with appropriate methods

In actual design and installation, the standard depth of undermount kitchen sinks is typically between 18 cm and 25 cm (approximately 7 to 10 inches). However, this is only a general reference range. The specific choice should be made in conjunction with the kitchen countertop height and the user's height.

Moderately increasing the thickness can indeed enhance the stability and lifespan of the sink. However, beyond a certain range (such as exceeding 1.5mm), the benefits diminish significantly. For example: • Limited increase in strength from thicker sinks; • Significantly increased weight, making installation more difficult; • Increased cost, but little improvement in daily user experience.